Compare any two graphics cards:
Radeon HD 6570 (OEM) 2GB vs Radeon HD 7770
IntroThe Radeon HD 6570 (OEM) 2GB has a clock speed of 650 MHz and a GDDR5 memory frequency of 1000 MHz. It also uses a 128-bit bus, and makes use of a 40 nm design. It is comprised of 480 SPUs, 24 Texture Address Units, and 8 ROPs.Compare that to the Radeon HD 7770, which features core speeds of 1000 MHz on the GPU, and 1125 MHz on the 1024 MB of GDDR5 RAM. It features 640 SPUs along with 40 TAUs and 16 ROPs.
Display Graphs
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically, the Radeon HD 7770 should be a little bit faster than the Radeon HD 6570 (OEM) 2GB in general. (explain)
Texel RateThe Radeon HD 7770 will be much (approximately 156%) better at anisotropic filtering than the Radeon HD 6570 (OEM) 2GB. (explain)
Pixel RateIf running with high levels of AA is important to you, then the Radeon HD 7770 is a better choice, by far. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Memory bandwidth is the largest amount of information (in units of megabytes per second) that can be transferred over the external memory interface in one second. It is worked out by multiplying the card's interface width by its memory speed. If the card has DDR type RAM, the result should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The better the memory bandwidth, the better the card will be in general. It especially helps with anti-aliasing, High Dynamic Range and higher screen resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be applied per second. This is worked out by multiplying the total texture units by the core speed of the chip. The higher this number, the better the card will be at handling texture filtering (anisotropic filtering - AF). It is measured in millions of texels processed in a second. Pixel Rate: Pixel rate is the maximum number of pixels that the graphics chip can possibly record to the local memory in a second - measured in millions of pixels per second. The figure is worked out by multiplying the amount of ROPs by the the core speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for drawing the pixels (image) on the screen. The actual pixel fill rate also depends on many other factors, most notably the memory bandwidth of the card - the lower the bandwidth is, the lower the ability to reach the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!