Compare any two graphics cards:
GeForce GTX 1070 Ti vs Radeon RX 570
IntroThe GeForce GTX 1070 Ti features a GPU core speed of 1607 MHz, and the 8192 MB of GDDR5 RAM is set to run at 2000 MHz through a 256-bit bus. It also is made up of 2432 Stream Processors, 152 TAUs, and 64 Raster Operation Units.Compare all that to the Radeon RX 570, which features a clock frequency of 1168 MHz and a GDDR5 memory frequency of 1750 MHz. It also uses a 256-bit memory bus, and uses a 14 nm design. It is comprised of 2048 SPUs, 128 Texture Address Units, and 32 ROPs.
Display Graphs
BenchmarksThese are real-world performance benchmarks that were submitted by Hardware Compare users. The scores seen here are the average of all benchmarks submitted for each respective test and hardware.
3DMark Fire Strike Graphics Score
Power Usage and Theoretical BenchmarksPower Consumption (Max TDP)
Memory BandwidthTheoretically speaking, the GeForce GTX 1070 Ti is 14% faster than the Radeon RX 570 in general, due to its greater data rate. (explain)
Texel RateThe GeForce GTX 1070 Ti should be much (more or less 63%) more effective at AF than the Radeon RX 570. (explain)
Pixel RateIf running with a high resolution is important to you, then the GeForce GTX 1070 Ti is superior to the Radeon RX 570, by a large margin. (explain)
Please note that the above 'benchmarks' are all just theoretical - the results were calculated based on the card's specifications, and real-world performance may (and probably will) vary at least a bit. Price Comparison
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though. Specifications
Display Specifications
Memory Bandwidth: Bandwidth is the largest amount of data (counted in MB per second) that can be transported over the external memory interface in a second. The number is calculated by multiplying the card's interface width by its memory speed. If the card has DDR RAM, the result should be multiplied by 2 again. If it uses DDR5, multiply by 4 instead. The higher the memory bandwidth, the better the card will be in general. It especially helps with AA, HDR and high resolutions. Texel Rate: Texel rate is the maximum amount of texture map elements (texels) that can be processed in one second. This figure is calculated by multiplying the total amount of texture units of the card by the core speed of the chip. The higher this number, the better the graphics card will be at texture filtering (anisotropic filtering - AF). It is measured in millions of texels applied per second. Pixel Rate: Pixel rate is the maximum amount of pixels that the graphics card could possibly record to the local memory in a second - measured in millions of pixels per second. Pixel rate is calculated by multiplying the amount of ROPs by the the core speed of the card. ROPs (Raster Operations Pipelines - aka Render Output Units) are responsible for filling the screen with pixels (the image). The actual pixel fill rate also depends on lots of other factors, especially the memory bandwidth of the card - the lower the memory bandwidth is, the lower the ability to get to the maximum fill rate.
Display Prices
Please note that the price comparisons are based on search keywords - sometimes it might show cards with very similar names that are not exactly the same as the one chosen in the comparison. We do try to filter out the wrong results as best we can, though.
|
Comments
Be the first to leave a comment!